C2g 37003 Module Manual de usuario descargar pdf

Mounting the enclosure: (see Fig. 1)

1. Using the mounting tabs or side slots to mount the

enclosure between the stubs, or using mounting holes

provided in the back of the unit for surface mounting.

Note - Be sure to leave enough space both on the top

and bottom of the unit for wire routing and the "UP"

arrow should face to the top.

2. When using the side slots, position the enclosure with

the front to protrude beyond the wallboard surface,

which will match the finished wall. Mark the center

of the mounting slots, this allows for further adjustment

to match the finished wall. Drill pilot holes and install

the enclosure with wood screws. When using the

mounting tabs, select the proper holes (A-5/8", B-1/2"

or C-3/8") for wallboard. When using the mounting

holes, attach the unit to the wall with screw anchors

recommended to support the weight of the enclosure

and variety of modules.

Remove the knockouts for wiring: (see Fig. 2)

Remove the knockouts which can be found on the top,

bottom, sides and back of the enclosure as needed for

wiring. Insert a screwdriver into the slot and bend to

break the knockout. Insert the plastic grommets in the

opening to protect cables from being damaged.

G ND

C - 3/8"

B - 1/2"

A- 5/8"

1 2

Mounting the enclosure: (see Fig. 1)1. Using the mounting tabs or side slots to mount the enclosure between the stubs, or using mounting holes

Installing the cover: (see Fig. 4)Hook the cover on the enclosure then screw it via mounting holes on the cover.2.0 in1.5 in87OUT PU TEX PA NS IONTO

Modelos relacionados 37002 Module | 37001 Module |

Sin comentarios